Laptop Photos

Since I lost the camera I've had no photos. I used the laptops webcam to catch the layup of the new fuel tank. It is 6 layers of cut mat fiberglass with polyester resin.

The center divider is a partition to make it two tanks. The others are just baffles.
I had them make depressions in the bottom of each tank to trap water etc. The tank pickups will be right in the center if these 'sumps' so any water immediately winds up in the water separator filter. Also, you can almost see the area for the wiring channel just above the center partition.


The baffles have holes large enough to clean the tank through.


The wood will all be removed before finishing and putting the top on.